Mitsubishi Electric MELSEC iQ-R04ENCPU - Current Password; FTP Server Settings; FTP Timer Settings; Password Setting

252
2 PARAMETER SETTINGS
2.3 Application Settings
FTP Server Settings
Set the file transfer function (FTP server).
Password Setting
■Current Password
Enter the current password for login to the Ethernet-equipped module.
Default password (initial setting) is the following.
Although the default password can be used, it is recommended to change it to another password to prevent unauthorized
access.
■New Password, Confirm New Password
Enter the new password in "New Password" and "Confirm New Password" when changing the password.
Set a password within 0 to 32 one-byte characters. Number, alphabet, special character (?,!&\%#*) can be used.
FTP Timer Settings
■Command Input Monitoring Timer
Set the monitoring time for the Ethernet-equipped module to monitor the command input time from the FTP client
It is recommended to use the default value (900s) for this timer value as much as possible.
When changing the setting value, determine the command input monitoring timer value upon consulting with the administrator
of the external device or system.
Set a value within the following range.
*1 Set in increments of 100ms.
The FTP connection is disconnected if there is no command input from the FTP client side within the time of the command
input monitoring timer value after the FTP client login.
When restarting the file transfer, start over from the login operation again.
Item Description Setting range
FTP Server Select whether to use the file transfer function (FTP server) of the
Ethernet-equipped module.
•Not Use
•Use
(Default: Not Use)
Login Name Set the login name to be used for file transfer request (login) from the
external device.
12 characters maximum (one-byte
alphanumeric character)
[Default]
• RJ71EN71 and RnENCPU (network
part): RJ71EN71
• CPU module (built-in Ethernet port
part): RCPU
Advanced
Settings
Password Setting Set the password to be used for file transfer request (login) from the
external device. ( Page 252 Password Setting)

FTP Timer Settings Set the following timers used for the file transfer function (FTP server).
( Page 252 FTP Timer Settings)
• Command Input Monitoring Timer
• Response Monitoring Timer

Allow Online Change Select whether to enable data writing from the external device using
the file transfer function (FTP server) while the CPU module is in RUN
state.
• Disable
• Enable
(Default: Disable)
Module Password
RJ71EN71, RnENCPU (network part) RJ71EN71
CPU module (built-in Ethernet port part) RCPU
Unit Setting range
s 1 to 16383
ms
*1
100 to 16383000