Mitsubishi Electric MELSEC iQ-R08ENCPU - Execution Timing; Specified Time (Hour, Minute, Day of Week); Time Setting

2 PARAMETER SETTINGS
2.3 Application Settings
259
2
Time Setting
Set the time setting function (SNTP client).
The SNTP server must be only one in a network. The time to be output is the same even though multiple
modules in the same system retrieve time from the same SNTP server.
Execution Timing
■Specified Time (Hour, Minute, Day of Week)
Set an execution time value within the following range in "Clock Time (Hour, Minute)".
To specify the day of the week when time setting is executed, set "Not Set" in the day when time setting is not executed under
"Day of Week". (Time setting is set to be executed every day (all the days are set to "Set") by default.)
When specifying the day of the week, set at least one day of the week to "Set". An error occurs when all the days are set to
"Not Set".
Item Description Setting range
Time Setting (SNTP Client) Select whether to use the time setting function (SNTP client). • Not Use
•Use
(Default: Not Use)
SNTP Server IP Address Set the IP address of the SNTP server. 0.0.0.1 to 223.255.255.254
(Default: 0.0.0.1)
Timer Setting After Power-on and Reset Select whether to execute the time setting function upon power-on or
reset.
• Disable
• Enable
(Default: Disable)
Execution
Timing
 Select the execution timing of the time setting. • Fixed Time
• Fixed Scan Interval
(Default: Fixed Time)
Time Intervals When "Fixed Scan Interval" is selected, set the time interval (minute) of
time setting executions.
1 to 1440
(Default: 1 Minute)
Specified Time (Hour,
Minute, Day of Week)
When "Fixed Time" is selected, set the day of the week and the clock
time (hour and minute) when the time setting function is executed.
( Page 259 Specified Time (Hour, Minute, Day of Week))

Item Setting range
Hour 0 to 23
(Default: 12)
Minute 0 to 59
(Default: 0)