2 COMMON PARAMETERS
2.2 R Series Common Parameter
53
2
System parameter
These parameters are used to set the Multiple CPU system module configuration and common system items. The system
parameters for each CPU in the Multiple CPU system must be matched. There is no need to set system parameters because
the parameters set in the GX Works3 "Module Configuration" or "System Parameter" are read by MT Developer2. However,
the "Refresh (END) setting", "Refresh (I45 executing) setting", and "Q compatibility high-speed refresh setting" in the
communication setting between CPU can be set based on the Motion CPU settings.
[R Series Common Parameter] [System Parameter] [Multiple CPU Setting] "Communication Setting between
CPU"
*1 Q compatibility high-speed refresh setting
Item Setting range Default
Multiple CPU
setting
Communication
setting between
CPU
Refresh (END) setting
*1
Up to 32 settings for each CPU
No. of points: Refer to device list for allowable setting range.
(Page 75 Device List)
Start: Usable devices (X, Y, M, B, D, W, #)
No setting
Refresh (I45 executing) setting Up to 32 settings for each CPU
No. of points: Refer to device list for allowable setting range.
(Page 75 Device List)
Start: Usable devices (X, Y, M, B, D, W, #)
No setting
Setting range Default
Up to 128 settings for each CPU
No. of points: 2 to 256
Start: Usable devices (X, Y, M, B, D, W, #)
No setting
To Next Page
Loading...
