Mitsubishi Electric MELSEC iQ-RJ71C24-R2 - Performing Circuit Trace

110
5 DEBUG SUPPORT FUNCTION
5.1 Circuit Trace
Performing circuit trace
The trace data is stored in the monitor buffer to trace the communication data and communication control signal status.
Operating procedure
1. Select [Tool][Intelligent Function Module Tool][Serial Communication Module][Circuit Trace] in Engineering tool.
2. Click the [Module Selection] button to select the module to be traced in the "Module Selection (Circuit Trace)" screen.
3. Select the channel to be traced from "Channel Selection", and click the [Start Trace] button.
4. When the monitor buffer is full, or the [Stop Trace] button is clicked, the trace data are displayed.
5. Confirm the send/receive packets and communication control signals from the displayed trace result.
Window