554
APPENDICES APPENDIX
Appendix 7 When Connecting the Module to a Remote Head Module
Program example of predefined protocol
The following shows the program examples to connect an external device (temperature controller) to the CH2 of C24, and to
execute the predefined protocol.
■Module parameter setting of C24
1. Set the items in "Basic Settings" of "Module Parameter" as follows.
[Navigation window] [Parameter] [Module Information] [RJ71C24] [Module Parameter] [Basic Settings]
2. Write the set parameters to the remote head module of the intelligent device station on CC-Link IE Field Network. Then,
reset the remote head module or power the system off and on.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
MELSEC iQ-R CC-Link IE Field Network User's Manual (Application)
Page 422 PARAMETER SETTING
■Predefined protocol support function setting of C24
1. Select [Tool][Predefined Protocol Support Function] from an Engineering tool.
2. Select "Serial Communication Module" in "Module Type" on the "Predefined Protocol Support Function" screen.
To Next Page
Loading...
