4 PROGRAMMING
4.1 Program Example of UCMM Message Communications
99
4
Setting parameters
Use the engineering tool to set the parameters.
Engineering tool settings
■RJ71EIP91 (client) settings
Connect the engineering tool to the scanner-side CPU module and set the parameters.
1.
Set the CPU module as follows.
[Project] Ö [New]
2.
Click the [Setting Change] button to use the module label.
3.
Click the [OK] button to add the module labels of the CPU module.
4.
Set the RJ71EIP91 as follows.
[Navigation window] Ö [Parameter] Ö [Module Information] Ö Right-click Ö [Add New Module]
To Next Page
Loading...
