Mitsubishi Electric MELSEC iQ-RJ71EIP91 - Page 168

166
APPX
Appendix 4 Details of Message Communication Support Command
*1 Arrays are displayed in combination with Interface Speed. This indicates the speed and Duplex mode supported by the module.
■Details of status flag
Instance service
12 HC
Interface
Counters
HCInOctets ULINT Number of octets received through the
interface
Value on the left
HCInUcastPkts ULINT Number of unicast packets received
through the interface
Value on the left
HCInMulticastPkts ULINT Number of multicast packets received
through the interface
Value on the left
HCInBroadcastPkts ULINT Number of broadcast packets received
through the interface
Value on the left
HCOutOctets ULINT Number of octets sent through the
interface
Value on the left
HCOutUcastPkts ULINT Number of packets sent through the
interface
Value on the left
HCOutMulticastPkts ULINT Number of multicast packets sent
through the interface
Value on the left
HCOutBroadcastPkts ULINT Number of broadcast packets sent
through the interface
Value on the left
13 HC Media
Counters
HCStatsAlignmentErrors ULINT 64-bit version of Alignment Errors Value on the left
HCStatsFCSErrors ULINT 64-bit version of FCS Errors Value on the left
HCStatsInternalMacTransmitE
rrors
ULINT 64-bit version of MAC Transmit Errors Value on the left
HCStatsFrameTooLongs ULINT 64-bit version of Frame Too Long Value on the left
HCStatsInternalMacReceiveEr
rors
ULINT 64-bit version of MAC Receive Errors Value on the left
HCStatsSymbolErrors ULINT Number of illegal data symbols in the
media when a valid carrier exists
0
Bit Description Value
0 Link-up status • 0: Link-down
•1: Link-up
1 Connection status (full-duplex/half-duplex) • 0: Half-duplex
• 1: Full-duplex
2 to 4 Auto-negotiation status • 0: Auto-negotiation being executed
• 1: Auto-negotiation failed and operation in progress with the default communication speed
and method
• 2: Communication method detection failed, but communication speed detection
succeeded
• 3: Auto-negotiation completed successfully
• 4: Auto-negotiation unexecuted
5 Necessity of restart after manual settings Fixed to 0 (because manual settings are not supported)
6 Local Hardware Fault detection status Fixed to 0 (because Local Hardware Faults are not detected)
7 to 31 Fixed value 0
Service code Service
01H Get_Attributes_All
0EH Get_Attribute_Single
4CH Get_and_Clear
Attribute
ID
Access
(: Available, :
Not available)
Name Data
type
Description Setting value
(Set)/stored
value (Get)
Get Set