Mitsubishi Electric MELSEC iQ-RJ71EIP91 - Page 35

1 FUNCTIONS
1.1 EtherNet/IP Communication Functions
33
1
Tag name that is already used for the same IP address on the Producer side cannot be set.
■Settings of the RJ71EIP91 on the Consumer side
Use EtherNet/IP Configuration Tool to register the RJ71EIP91(1) on the Consumer side. Then, set the tag communications.
For registering the RJ71EIP91 on the Consumer side, refer to the following.
Page 94 Procedure for Registering EtherNet/IP Devices
Set the RJ71EIP91 on the Consumer side from the window shown below.
Select "Target (Class1 Tag)" in the network configuration settings Ö [Device] Ö [Properties]
Tag name that is already used on the Consumer side cannot be set.
(1) Tag name on the Producer Tag side
(2) Data Size on the Producer Tag side
(1)
(2)
(1)