2 PARAMETER SETTINGS
2.1 Procedure for Setting Parameters
43
2
2
PARAMETER SETTINGS
This chapter describes the parameter settings required for communications between the RJ71EIP91 and EtherNet/IP devices.
2.1
Procedure for Setting Parameters
1.
Add the RJ71EIP91 in the engineering tool.
[Navigation window] Ö [Parameter] Ö [Module Information] Ö Right-click Ö [Add New Module]
2.
The basic settings, application settings, and refresh settings are included in the module parameters. Select the settings
from the navigation tree in the following window and configure them.
[Navigation window] Ö [Parameter] Ö [Module Information] Ö [RJ71EIP91]
3.
Use the engineering tool to write the module parameters to the CPU module.
[Online] Ö [Write to PLC]
4.
The settings are reflected by resetting the CPU module or powering off and on the system.
5.
Start EtherNet/IP Configuration Tool, and then set the EtherNet/IP communication parameters.
6.
Use EtherNet/IP Configuration Tool to write the EtherNet/IP communication parameters to the RJ71EIP91.
To Next Page
Loading...
