3 EtherNet/IP Configuration Tool
3.1 Window Structure
65
3
■[Ping] tab
Check for the existence of the EtherNet/IP device with the specified IP address over EtherNet/IP.
Item Description Setting range
Address IP Address Specifies the IP address of the EtherNet/IP device to ping. 0.0.0.0 to 255.255.255.255
(Default: Current IP address of
the EtherNet/IP device)
Ping [Ping] button Pings the specified EtherNet/IP device.
Loop Select this check box to repeatedly ping the device once every
100ms.
•Selected
• Not selected
(Default: Not selected)
Stop on Error Sets whether to interrupt pinging if an error occurs when the
"Loop" check box is selected.
• Selected: Pinging will be interrupted if an error occurs.
• Not selected: Pinging will continue even if an error occurs.
•Selected
• Not selected
(Default: Not selected)
[Clear] button Deletes the content of "Ping Result".
Ping Result Displays the result of pinging.
To Next Page
Loading...
