2 PARAMETER SETTINGS
2.4 Application Settings
137
2
2.4 Application Settings
Set the supplementary cyclic settings, interrupt settings, or other parameters for the master/local module.
: Can be set, : Cannot be set
Item Description Availability Reference
Master
station
Local station Submaster
station
Supplementary Cyclic
Settings
Set the system switching monitoring time, link
scan mode, station-based block data assurance,
and I/O maintenance setting.
*1
Page 139
Supplementary Cyclic
Settings
Interrupt Settings Set conditions for sending an interrupt request to
the CPU module.
Page 141 Interrupt
Settings
IP Address Set the IP address of the master station and
submaster station to communicate with Ethernet
device over CC-Link IE Field Network.
*1
Page 144 IP Address
Communication Mode Set the communication mode of the own station. Page 145
Communication Mode
Parameter Name Set a name for the module parameter if desired. Page 145 Parameter
Name
Dynamic Routing Select whether to enable the dynamic routing
function.
Page 145 Dynamic
Routing
Event Reception from
Other Stations
Select whether to obtain the events occurring in
the other stations.
Page 146 Event
Reception from Other
Stations
Module Operation Mode Set the mode of the master/local module. Page 147 Module
Operation Mode
Interlink Transmission
Settings
Set link device ranges when cyclic data are
transferred from a station in the own network to a
station in another network.
Page 147 Interlink
Transmission Settings
Safety Communication
Setting
Set whether to use the safety communication
function or not and set the safety connections
and transfer ranges of safety devices.
This item can be set only in a project of the SIL2
Process CPU or the Safety CPU.
*2
*3
Page 151 Safety
Communication
Setting
To Next Page
Loading...
