278
4 TROUBLESHOOTING
4.6 List of Parameter Numbers
4.6 List of Parameter Numbers
This section lists the parameter numbers displayed in the module diagnostics.
Item Parameter No.
System
Parameter
Inter-module Synchronous
Setting
Select Inter-module Synchronization Target Module 0101H
Fixed Scan Interval Setting of Inter-module Synchronization 0101H
Required Settings 7100H
Basic Settings Network Configuration
Settings
No. A040H
STA# A044H
Station Type A044H
A042H
RX/RY Setting A041H
A042H
RWw/RWr Setting A041H
A042H
Reserved/Error Invalid Station/System Switching Monitoring Target
Station
• Reserved Station: A001H
• Error Invalid Station: A002H
• System Switching Monitoring
Target Station: A004H
Pairing A003H
Network Synchronous Communication A045H
Alias A011H
Comment A011H
Refresh Settings 7401H
Network Topology A040H
Submaster Parameters A042H
Operation of Master Station after Reconnection 7100H
Application
Settings
Supplementary Cyclic
Settings
System Switching Monitoring Time 7100H
Link Scan Mode A040H
Station-based Block Data Assurance A040H
I/O Maintenance Settings Output Hold/Clear Setting during CPU
STOP
A050H
Data Link Error Station Setting A050H
Output Mode upon CPU Error 7101H
Interrupt Settings A014H
A015H
7800H
IP Address A012H
Communication Mode A050H
Parameter Name 7310H
Dynamic Routing A050H
Event Reception from Other Stations A016H
Module Operation Mode 7100H
Interlink Transmission Settings 7500H
Safety Communication
Setting
To Use of Not to Use the Safety Communication Setting 7100H
Safety Communication
Setting
When the safety communication function
is used in a system using the Safety
CPU
A017H
When the safety communication function
is used in a system using the SIL2
Process CPU
A01AH
Redundant System Settings Station No. (System B) 7110H
Module Operation Mode (System B) 7110H
To Next Page
Loading...
