Mitsubishi Electric MELSEC iQ-RJ71GF11-T2 - Page 283

4 TROUBLESHOOTING
4.7 Event List
281
4
Operation
*1 Only occurs in the master station.
*2 Only occurs in the local station.
Event code Overview Cause
24000 Data link startup instruction Data link startup to the own station or another station was instructed.
24001 Data link stop instruction Data link stop to the own station or another station was instructed.
24010 Temporary error invalid station setting instruction Temporary error invalid station setting was instructed to the slave station.
24011 Temporary error invalid station cancel instruction Temporary error invalid station cancel was instructed to the slave station.
24020 Reserved station cancel setting instruction Reserved station cancel setting was instructed to the slave station.
24021 Reserved station enable setting instruction Reserved station enable setting was instructed to the slave station.
24030
*1
The network number, station number setting/change
instruction execution
Setting or change of the network number or station number was instructed to the
slave station.
24031
*2
Network number station number setting/change execution Setting or change of the network number or station number of the own station
was executed.
24100 <<Own station>> Parameter change/new parameter
acceptance
Parameter was changed. Or new parameter was received at power-on.
24F00 <<Another station>> CPU operating status change
detection
Operating status of the programmable controller CPU on another station was
changed.