1 FUNCTIONS
1.3 IP Packet Transfer Function
47
1
Routing parameter setting
Set routing parameters in the following cases.
• When modules other than MELSEC iQ-R series exist in the communication path
• When an Ethernet device needs to be connected to a module that does not support routing parameters
■When modules other than MELSEC iQ-R series exist in the communication path
To set routing parameters, refer to the following.
MELSEC iQ-R CPU Module User's Manual (Application)
■When an Ethernet device needs to be connected to a module that does not support routing
parameters
When an Ethernet device needs to be connected to a module, such as an Ethernet adapter module, that does not support
routing parameters, set the routing parameters so that communications are transmitted through the master station.
Communications from a module that does not have the routing parameters are automatically transmitted through the master
station. The communication paths must be the same for data sending and receiving; therefore, set the routing parameters so
that communications are transmitted through the master station.
Proper setting
A
B
C
023121
223
Ethernet device
(request source device)
Ethernet device
(request destination device)
Local station
Master station
Network No.1 Network No.2
Communication routes set using the routing parameters
Communication route automatically set (from a module that
does not have the routing parameters to the master station)
Network No.3
Station
No.2
Station
No.1
Station
No.0
Setting for
Network No.
Relay station
Station
Setting for Setting for
The setting is not required
because the module does not
have the routing parameters.
Set this column to pass communications
through the master station.
Network No.
Target station
Network No.
Relay station
Station Network No.
Target station
ABC
To Next Page
Loading...
