110
9 CREATING A HARDWARE LOGIC
9.1 Main Blocks in the Hardware Logic Outline Window
OUT terminal
In the first section in the hardware logic outline window, eight OUT terminals for DC output ("OUT 0" to "OUT 7") and six OUT
terminals for differential output ("OUT 0_DIF" to "OUT 5_DIF") are arranged by default.
Signals output from external output blocks in the fifth section can be used as inputs in the hardware logic. For details on the
external output block, refer to the following.
Page 123 External output block
Output
The following table shows the output of the OUT terminal.
*1 Any of OUT 0 to OUT 7 or OUT 0_DIF to OUT 5_DIF can be linked to a logical operation block when a Y device terminal is not linked to
the logical operation block.
When "Logic Select" of an external output block is set to "Inversion", signals input to the external output block
are inverted and output from the OUT terminal.
For details on the external output block, refer to the following.
Page 123 External output block
Variable name Data type Linkable block Valid range Description
Input Bit • Multi function counter
• Logical operation
*1
0, 1 When no external output blocks are linked, no signals
are output from this terminal.
To Next Page
Loading...
