9 CREATING A HARDWARE LOGIC
9.1 Main Blocks in the Hardware Logic Outline Window
111
9
Parallel encoder block
In the second section in the hardware logic outline window, one parallel encoder block ("Parallel_Encoder") can be arranged.
The parallel encoder block transmits data with the encoder for parallel transmission and receives the data of the bit points set
in the data length setting as the data of Input Data Type to convert this data into word data.
Input
The following table shows the inputs of the parallel encoder block.
Variable name Data type Linkable block Valid range Description
Input 0 Bit External input 0, 1 These are input terminals of the parallel encoder.
When the data length is changed, the number of
displayed Input terminals is changed according to the
data length. Then, the Input terminals are automatically
linked to external input blocks in order from the first one
("IN 0"). The order of linking the Input terminals and the
external input blocks cannot be changed.
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Input 8
Input 9
Input A
Input B
To Next Page
Loading...
