10 BLOCK LINK EXAMPLES
10.9 Pulse Measurement
201
10
10.9 Pulse Measurement
The ON width or OFF width of an input signal is measured.
The following describes a link and parameter example of a pulse measurement. With the example setting, the ON width (latch
value × 25ns) of the input signal is measured. Note that this link example is for when a 32-bit unsigned multi function counter
block is used.
Link and parameter
The following shows a link example of the hardware logic outline window and a link example and parameter setting example
of the multi function counter block detail window.
■Hardware logic outline window
ON
OFF
Input signal
ON width OFF width
To Next Page
Loading...
