210
13 PROGRAMMING
13.1 Programming Procedure
13 PROGRAMMING
This chapter describes the programming procedure and basic programs of the flexible high-speed I/O control module.
13.1 Programming Procedure
Create programs for executing the flexible high-speed I/O control module with the following procedure.
*1 Set the hardware logic with the configuration tool.
*2 Create programs with GX Works2.
Program creation start
Outline window setting
Hardware logic start/stop program
Module addition with GX Works2
Program creation end
Error reset program
Program
*2
Multi function counter block setting
Hardware logic
*1
To Next Page
Loading...
