Mitsubishi Electric MELSEC-L Series LD40PD01 - 13.3 When the Module Is Connected to a Head Module

13 PROGRAMMING
13.2 When the Module Is Used with the Standard System Configuration
215
13
Program example
■User devices
■Program example
Device Description
M0 Hardware logic control start
M1 Hardware logic control stop
M2 Operating condition settings batch-reset
M3 Error reset command
X30 Module ready
X33 Operating condition settings batch-reset complete flag
X34 Hardware logic control flag
X3F Error flag
Y33 Operating condition settings batch-reset command
Y34 Hardware logic control start request
Y35 Hardware logic control stop request
Y3F Error clear request
Store a value of Clear setting of
error history.
Turn on Error clear request.
Turn off Error clear request.
Turn on Hardware logic control
start request.
Turn off Hardware logic control
start request.
Turn on Hardware logic control
stop request.
Turn off Hardware logic control
stop request.
Turn on Operating condition
settings batch-reset command.
Turn off Operating condition
settings batch-reset command.