13 PROGRAMMING
13.3 When the Module Is Connected to a Head Module
217
13
13.3 When the Module Is Connected to a Head Module
This section shows a program example with the following system configuration and conditions of the flexible high-speed I/O
control module.
System configuration
Programming conditions
The program counts pulses (2-phase multiple of 4) input to the flexible high-speed I/O control module with the multi function
counter block.
Network No.1
Ethernet cable (1000BASE-T)
X/Y1000
to
X/Y101F
Masster station (Station No.0)
Intelligent device station (Station No.1)
Power supply module (Q62P)
CPU module (Q10UDHCPU)
Master/local module (QJ71GF11-T2)
Input module (QX10)
Output module (QY40P)
Power supply module (L61P)
Head module (LJ72GF15-T2)
Flexible high-speed I/O control module (LD40PD01)
END cover (L6EC)
X/Y00
to
X/Y1F
X/Y20
to
X/Y2F
X/Y30
to
X/Y3F
To Next Page
Loading...
