Mitsubishi Electric MELSEC-L Series LD40PD01 - Page 229

13 PROGRAMMING
13.3 When the Module Is Connected to a Head Module
227
13
■Program example 3
A program example to start the hardware logic control
■Program example 4
A program example to stop the hardware logic control
■Program example 5
A program example to read the count value
■Program example 6
A program example to reset the operating condition settings in a batch
(1) Turn on Hardware logic control start request (Y1004).
(2) Turn off Hardware logic control start request (Y1004).
(1) Turn on Hardware logic control stop request (Y1005).
(2) Turn off Hardware logic control stop request (Y1005).
(1) Read the count value.
(1) Turn on Operating condition settings batch-reset command (Y1003).
(2) Turn off Operating condition settings batch-reset command (Y1003).
(1)
(2)
(1)
(2)
(1)
(1)
(2)