Mitsubishi Electric MELSEC-L Series LD40PD01 - List of I;O Signals

3 SPECIFICATIONS
3.4 List of I/O Signals
29
3
3.4 List of I/O Signals
The following table lists the I/O signals of the flexible high-speed I/O control module to the CPU module.
For details on the I/O signals, refer to the following.
Page 240 Details of I/O Signals
• The I/O numbers (X/Y) listed above are shown on the assumption that the start I/O number of the flexible
high-speed I/O control module is set to 0.
• The use prohibited signals listed above are used by the system and are not available for users. If a user
uses these signals (turning off and on), the performance of the flexible high-speed I/O control module is not
guaranteed.
Input (Signal direction: CPU module ← Flexible high-speed I/O
control module)
Output (Signal direction: CPU module → Flexible high-speed I/
O control module)
Device No. Signal name Device No. Signal name
X0 Module ready Y0 Use prohibited
X1 Use prohibited Y1 Use prohibited
X2 Use prohibited Y2 Use prohibited
X3 Operating condition settings batch-reset complete flag Y3 Operating condition settings batch-reset command
X4 Hardware logic control flag Y4 Hardware logic control start request
X5 Use prohibited Y5 Hardware logic control stop request
X6 Use prohibited Y6 Hardware logic control stop signal at disconnection
X7 Hardware logic control stop flag at disconnection Y7 Hardware logic control stop flag clear request at
disconnection
X8 Use prohibited Y8 Use prohibited
X9 Use prohibited Y9 Use prohibited
XA Use prohibited YA Use prohibited
XB Use prohibited YB Use prohibited
XC Use prohibited YC Use prohibited
XD Use prohibited YD Use prohibited
XE Use prohibited YE Use prohibited
XF Error flag YF Error clear request
X10 IN 0 Y10 General command 0
X11 IN 1 Y11 General command 1
X12 IN 2 Y12 General command 2
X13 IN 3 Y13 General command 3
X14 IN 4 Y14 General command 4
X15 IN 5 Y15 General command 5
X16 IN 6 Y16 General command 6
X17 IN 7 Y17 General command 7
X18 IN 8 Y18 General command 8
X19 IN 9 Y19 General command 9
X1A IN A Y1A General command A
X1B IN B Y1B General command B
X1C Use prohibited Y1C General command C
X1D Use prohibited Y1D General command D
X1E Use prohibited Y1E General command E
X1F Use prohibited Y1F General command F