Mitsubishi Electric MELSEC-L Series - Parameter Settings for Using Dedicated Instructions; When Using Data Link Instructions

197
CHAPTER 15 DEDICATED INSTRUCTIONS
15
15.2 Parameter Settings for Using Dedicated Instructions 15.2.1 When using data link instructions
15.2 Parameter Settings for Using Dedicated Instructions
When using dedicated instructions, set the parameters of each function.
15.2.1 When using data link instructions
When using data link instructions, set the following parameters.
• Station No. <-> IP information setting
• Routing parameters setting
For details on the settings, refer to the following.
MELSEC-Q/L Ethernet Interface Module User's Manual (Application)