59
CHAPTER 5 SYSTEM CONFIGURATION
5
5.2 Network Components
(2) 10BASE-T connection
To configure a system for 10BASE-T connection, use devices that meet the IEEE 802.3 10BASE-T standards.
*1 This applies when a repeater hub is used. For the number of levels that can be constructed when a switching hub is
used, consult with the manufacturer of the switching hub used.
*2 Data can be communicated with an E71 (between LJ71E71-100 modules). In addition, an E71 can be directly connected
to a GOT.
Consult a network specialist for required devices.
Configuration device Description
Unshielded twisted pair
cable (UTP) or shielded
twisted pair cable (STP)
*2
Straight cable
A Category 3, 4, or 5 straight cable or cross cable is usable.
Cross cable
Connector RJ45 connector
Hub 10Mbps hub
Up to four levels of cascade connection can be configured.
*1
To Next Page
Loading...
