Mitsubishi Electric MELSEC-Q Series - Page 122

4 - 1
4 PARAMETERS FOR POSITIONING CONTROL
4
4. PARAMETERS FOR POSITIONING CONTROL
4.1 System Settings
In the Multiple CPU system, the common system parameters and individual
parameters are set for each CPU and written to each CPU.
(1) The base settings, Multiple CPU settings and Motion slot settings are set in the
common system parameter setting.
(2) The following are set in the individual parameter setting.
• System basic setting
• SSCNET setting
QDS
• CPU name setting
• Built-in Ethernet port setting
• CPU setting
• Manual pulse generator/synchronous encoder setting
QDS
• Servo amplifier setting
• High-speed read setting
• Optional data monitor setting
• Mark detection setting
QDS
(3) The data setting and correction can be performed in MT Developer2.
(Refer to the "Q173D(S)CPU/Q172D(S)CPU Motion Controller Programming
Manual (COMMON)" for details of the setting contents.)