163
CHAPTER 5 PREPARATION AND SETUP
5
5.5 Wiring
(2) Cable connection
(a) Connection method
Connect an optical fiber cable between OUT and IN as shown below.
Note that there is no need to connect the cables in the order of station numbers.
(b) Connecting the optical fiber cable
(c) Disconnecting the optical fiber cable
IN
OUT
IN
OUT
IN
OUT
Control station
Station No.1
Normal station
Station No.2
Normal station
Station No.n
n 120
CC-Link IE Controller Network module
Connector hook
Module-side
connector
CC-Link IE Controller
Network module
Cable-side
connector
Connection
Turn OFF the power.
Connect the cable-side connector to the
module-side one, paying attention to the
orientation. Push it until a "click" can be
heard.
Lightly pull it to check that it is securely
connected.
End
Connector hook
Module-side
connector
CC-Link IE Controller
Network module
Cable-side
connector
Disconnection
Turn OFF the power.
Press the connector hook to disconnect
the cable.
End
To Next Page
Loading...
