239
CHAPTER 6 PARAMETER SETTING
6
6.9 Routing Parameters
(1) Concept of routing parameters
To each station on the network, set a relay station in the own network to transmit data to another network.
Routing parameters set to each station on Network No.
Routing parameters are not necessary for stations that do not send any transient transmission to other networks, however, it
is recommended to set the same routing parameters to each network.
Target
Network No.
Relay
Network No.
Relay
Station No.
1
No setting is required for the
relay station because data
are transmitted via the station.
(Relay station)
"To go to network No. , data passes through station No. of its own network No. ."
Network No.
Network No.
To Next Page
Loading...
