Mitsubishi Electric MELSEC-Q Series - Page 274

272
(c) Refresh parameters
In the program example in this section, the following refresh parameters are assigned (control station (station
No. 1) for CC-Link IE Controller Network modules on station numbers 1 to 4.
1. Fill in the refresh parameter sheet. ( Page 657, Appendix 5.4)
Ex.
Control station (No. 1)
2. Complete settings in the programming tool based on the contents filled in the parameter sheet.
• Setting of refresh parameter (Control station (No. 1))
BLB
WLW
0 to 1FF
200 to 3FF
400 to 5FF
600 to 7FF
0 to 1FF
200 to 3FF
400 to 5FF
600 to 7FF
0 to 1FF
200 to 3FF
400 to 5FF
600 to 7FF
0 to 1FF
200 to 3FF
400 to 5FF
600 to 7FF
CC-Link IE Controller
Network module
CPU module
Station No.1
Station No.1
Station No.2Station No.2
Station No.3Station No.3
Station No.4Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1Station No.1
Station No.2Station No.2
Station No.3Station No.3
Station No.4Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1Station No.1
Station No.2Station No.2
Station No.3Station No.3
Station No.4Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1Station No.1
Station No.2Station No.2
Station No.3Station No.3
Station No.4Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Number of points
CPU module Data description
points
points
to
to
Transfer
1
2
CC-Link IE Controller
Network module
to
to