Mitsubishi Electric MELSEC-Q Series - Page 292

290
(b) Network range assignment
In the program example in this section, each station send range of LB/LW is assigned 512 points.
Use the default setting for the supplementary setting.
1. Fill in the network range assignment parameter sheet and the supplementary setting parameter
sheet. ( Page 652, Appendix 5.3)
Ex.
LB setting (Control station (1M
P
1)
CC-Link IE Controller
Network module
LB0 to LB1FF
LB200 to LB3FF
LB0 to LB1FF
LB200 to LB3FF
1M P 1 send range
1N S 2
1M P 1
2N S 2 1N S 2 send range
2M P 1
2N S 2 send range
2M
P 1 send range
LW0 to LW1FF
LW200 to LW3FF
LW0 to LW1FF
: Set in network range assignment
: Set with interlink transmission parameters
LW200 to LW3FF
1M P 1 send range
1N S 2
1M P 1
2N S 2 1N S 2 send range
2M P 1
2N S 2 send range
2M
P 1 send range
LB
LW
Control
station
1M
P1
Control
station
2MP1
Normal
station
1NS2
Normal
station
2N
S2
Network No.1 Network No.2
Page 294, Section 8.2.2 (2)
(a) LB setting
Station No.
Link relay (LB) Number of points Data description
1
LB
points
points
to
LB to
2
Network No.
Total Stations
System Switching Monitoring Time
Data Link Monitoring Time
ms
ms
Parameter Name
(1) LB/LW setting [(1)/(2)]
Pairing Shared group