302
(c) Routing parameters
For the normal station (2N
S
2), set routing parameters in the following system configuration.
1. Fill in the routing parameter sheet. ( Page 662, Appendix 5.7)
Normal station (2N
S
2)
2. Complete settings in the programming tool based on the contents filled in the parameter sheet.
• Setting of routing parameters (Normal station (2N
S
2))
CC-Link IE Controller
Network module
Control
station
1M
P
1
Control
station
2M
P
1
Normal
station
1N
S
2
Normal
station
2N
S
2
Network No.1 Network No.2
"To go to network No.1, data passes through station No.1 of its own network No.2."
211
No setting is required for relay station (2M
P
1)
because data are transmitted via the station.
No.
Target
Network No.
Relay
Network No.
Relay
Station No.
1
No.
Target
Network No.
Relay
Network No.
1
Relay
Station No.
To Next Page
Loading...
