Mitsubishi Electric MELSEC-Q Series - Error Codes; Checking the Error Code

511
CHAPTER 10 TROUBLESHOOTING
10
10.2 Error Codes 10.2.1 Checking the error code
10.2 Error Codes
This section describes a read operation of error codes and error codes in the CC-Link IE Controller Network module.
10.2.1 Checking the error code
Check the error code in "Module's Detailed Information" or "System Error History".
Remark
In GX Works2, the error history of the entire system can be checked even after an error has been removed by powering OFF
and ON or resetting the CPU module.
( Page 512, Section 10.2.1 (2))
(1) Checking the error code in the "Module's Detailed Information" window
Open the "Module's Detailed Information" window in the programming tool.
•In GX Works2
[Diagnostics] [System Monitor] button
• In GX Developer
[Diagnostics] [System Monitor] button
Error details and the solution can be checked by clicking the button ( button in GX
Developer) and selecting the error code.
Remark
When "Select Station" is changed in the "CC IE Control Diagnostics" window, error codes on other programmable controllers
on the network can be also checked. ( Page 526, Section 10.3)