527
CHAPTER 10 TROUBLESHOOTING
10
10.3 CC IE Control Diagnostics
*1 Selectable when the selected station is connected to the programming tool (the own station). Not selectable when it is
any other station.
*2 Not selectable in circuit test mode.
*3 Displayed only when GX Works2 is used.
Item Description
Change Module
When two or more CC-Link IE Controller Network modules are mounted, the "Select
Diagnostics Destination" window is displayed by clicking this button.
The network to be diagnosed is changed in the "Select Diagnostics Destination" window.
Select Station Specifies station No. of selected station.
Change Select Station
Enter the station No. in "Select Station", and click this button to change the selected
station.
Network information display
Page 528, Section 10.3.1
Select station network device
status display
Page 531, Section 10.3.2
Communication Test
*1*2
Page 174, Section 5.7.1
IP Communication Test
*3
Page 113, Section 4.3.3
Link Start/Stop
*1*2
Page 91, Section 4.1.12
Logging
*1*2
Page 533, Section 10.3.3
System Monitor
Page 536, Section 10.3.4
Remote Operation
Page 540, Section 10.3.5
To Next Page
Loading...
