Mitsubishi Electric MELSEC-Q Series - Page 548

546
(2) When a programming tool connected station is faulty
(3) When a programming tool connected station is disconnected from the network
Select the own station.
A communication error has occurred between the OUT-side of the station
No.2 and the IN-side of the station No.4.
An error has occurred in the station No.2.
Click the error details button.
The Error Factor field indicates that a cable has not been inserted into
the correct port.
Take corrective actions according to the troubleshooting.
Control station
No.1
Normal
station
No.2
Normal station
No.4
Normal station
No.3
Selected
station
An error has occurred in the station No.3.
Click the error details button.
The Error Factor field indicates that a cable has not been inserted into
the correct port.
Take corrective actions according to the troubleshooting.
Control station
No.1
Normal station
No.2
Normal station
No.4
Normal
station
No.3
Selected
station