557
CHAPTER 10 TROUBLESHOOTING
10
10.4 Checking the Error Description with the CC IE Control Diagnostics
10.4.8 Control station duplication
If it is difficult to identify the error cause, perform the CC IE Control diagnostics after the circuit test. ( Page 165,
Section 5.6.1)
(2) Adding station to a network
(a) When a programming tool connected station is normally operating
Select the own station.
An error has occurred in the station No.4.
Select the station No.4.
Click the error details button.
The Error Factor field indicates that a station other than the station No.4 has
been also set as the control station.
Take corrective actions according to the troubleshooting.
Control
station
No.1
Normal station
No.2
Control station
No.4
Normal station
No.3
Selected
station
Control station
No.1
Normal station
No.2
Control
station
No.4
Normal station
No.3
Selected
station
Added station
Added station
To Next Page
Loading...
