Mitsubishi Electric MELSEC-Q Series - Stop;Restart of Cyclic Transmission

91
CHAPTER 4 FUNCTIONS
4
4.1 Cyclic Transmission Function 4.1.12 Stop/restart of cyclic transmission
4.1.12 Stop/restart of cyclic transmission
Receiving data from other stations and sending data of its own station can be disabled in a case such as debugging.
(Transient transmission is not stopped.)
Each station's cyclic transmission can be stopped or restarted with a programming tool.
Note that this function is not available in circuit test mode.
(1) Operation procedure
1. Open the "Link Start/Stop" window in the programming tool.
[Diagnostics] [CC IE Control Diagnostics] button
2. Operate the programming tool with reference to the following steps.
Cyclic transmission
Link refresh
LB0 LB0LB0LB0
B0
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
Station No.1
Station No.2
Station No.3
Station No.4
(Station No.4)(Station No.3)(Station No.2)
CC-Link IE Controller
Network module
CC-Link IE Controller
Network module
CC-Link IE Controller
Network module
CC-Link IE Controller
Network module
(Station No.1)
CPU module
Stop/restart of
cyclic transmission