Mitsubishi Electric MELSEC-Q Series - Page 216

7 REPLACEMENT OF PROGRAM
7 - 29
*1 For the number of mountable CC-Link modules and the number of settable parameters with the software package, refer to
the CC-Link System Master/Local Module User's Manual.
PLC RAS setting
WDT setting
WDT setting 
Initial execution monitoring time 
Low speed execution monitoring time  The Universal model QCPU does not support the low speed program.
Error check
Carry out battery check 
Carry out fuse blown check 
Carry out I/O module comparison 
Operation mode when
there is an error
Computation error 
Expanded command error 
Fuse blown 
I/O module comparison error 
Special module access error  The name changes to "Intelligent module program execution error".
Memory card access error 
Memory card operation error 
Constant scanning 
Annunciator
display mode
F No. display  The QCPU does not incorporate this display function.
Comment display  The QCPU does not incorporate this display function.
Occurrence time  The QCPU does not incorporate this display function.
Break down
history
Drive 
The storage location in the Universal model QCPU is fixed, therefore this setting does
not exist.
File name 
History No. 
Low speed program execution time  The Universal model QCPU does not support the low speed program.
I/O assignment Reviewing is required if the Q series CPU base unit has other than 8 slots.
Boot file setting 
Program setting 
SFC setting
SFC program start mode 
Start conditions 
Output mode when the block is stopped 
Network parameter
MELSECNET (II), /B 
Parameters are deleted, since the Q series CPU is not compatible with the
MESECNET (II), /B.
MELSECNET/10 (H)  Converted to the MELSECNET/10 mode.
MELSECNET/MINI 
Parameters are deleted, since the QCPU is not compatible with the MELSECNET/
MINI.
CC-Link 
The number of settable parameters with the software package is eight.
*1
Set the parameters of the ninth module or later with dedicated instructions.
Ethernet 
The "Use the KeepAlive" of "TCP Existence confirmation setting" in the "Ethernet
operations" is automatically set.
Name
Compat-
ibility
Remarks