11 - 14
Chapter 11 Manual Control
When the "JOG start signal" is turned ON again during deceleration caused
by the ON
OFF of the "JOG start signal"
When the "JOG start signal" is turned ON again during deceleration caused by the
ON
OFF of the "JOG start signal", the JOG operation will be carried out from
the time the "JOG start signal" is turned ON.
OFF
ON
t
BUSY signal [X10 to X1F]
OFF
ON
Forward run JOG operation
Cd.181 Forward run JOG start
Fig. 11.9 Operation when the JOG start signal is turned ON during deceleration
When the "JOG start signal" is turned ON while the test function of
GX Works2 is used
When the "JOG start signal" is turned ON while the test function of GX Works2 is
used, it will be ignored and the JOG operation will not be carried out.
In test mode flag
ON
t
OFF
ON
OFF
Forward run JOG
operation execution
JOG operation not possible
because this is not the
rising edge of the JOG
start signal
JOG operation not
possible because
the test function is
being used
Cd.181 Forward run JOG start
Fig. 11.10 Operation when the JOG start signal is turned ON while the test function is used
To Next Page
Loading...
