14 - 30
Chapter 14 Common Functions
(2) Mark detection control data
Setting item Setting details/setting value
Default
value
Buffer memory address
[Cd.800]
Number of mark
detection clear
request
Set "1" to execute "0" clear of number of mark detections.
"0" is automatically set after completion by "0" clear of
number of mark detections.
1: 0 clear of number of mark detections
Fetch cycle: Operation cycle
0 54640+10k
[Cd.801]
Mark detection
invalid flag
Set this flag to invalidate mark detection temporarily.
1 : Mark detection: Invalid
Others : Mark detection: Valid
Fetch cycle: Operation cycle
0 54641+10k
k: Mark detection setting No.-1
[Cd.800] Number of mark detection clear request
Set "1" to execute "0" clear of "[Md.800] Number of mark detection". "0" is
automatically set after completion by "0" clear of "[Md.800] Number of mark
detection".
[Cd.801] Mark detection invalid flag
Set "1" to invalidate mark detection temporarily. The mark detection signal during
invalidity is ignored.
To Next Page
Loading...
