6 - 20
6 INSPECTION AND MAINTENANCE
(c) Flowchart for when the 7-segment LED stops with an
initializing item (b00 to o99)
The following shows the flowchart for when the 7-segment LED stops with
an initializing item (b00 to o99).
YES
YES
NO
YES
NO
YES
NO
NO
1)
The 7-segment LED stopped with an
initializing item (b00 to o99)
Wait approximately 1 minute with the
initializing item displayed (b00 to o99)
Set the Motion CPU module rotary
switch 2 (SW2) to "C", and clear the
SRAM.
Set the Motion CPU module rotary
switch 1 (SW1) to "0", and rotary
switch 2 (SW2) to "0".
Did the
7-segment LED display
"STOP" or "RUN"?
Did the
7-segment LED display
change from the initializing
item (b00 to o99)?
END
Did the
7-segment LED display
"AL" "L01"?
(f)
Flowchart for when "AL" "L01"
displays on 7-segment LED
Did the
7-segment LED display
"AL" "A1" " "?
(g)
Flowchart for when "AL" "A1" " "
displays on 7-segment LED
To Next Page
Loading...
