Mitsubishi Electric Melsec-Q172DCPU - Page 66

2 - 33
2 SYSTEM CONFIGURATION
(c) Ethernet IP address display mode overview
7-segment LED Operation overview
Disconnect
Connect
(10Mbps)
Connect
(100Mbps)
Full duplex
Half duplex
IP address
(Note)
(ex. 192.168.3.39)
Subnet mask pattern
(Note)
(ex. 255.255.255.0)
Default router IP
address
(Note)
(ex. 192.168.3.1)
Link status
(Note): When the Ethernet parameters are not written in the Motion CPU, the addresses are
displayed as follows.
• IP address : 192.168.3.39
• Subnet mask pattern : 255.255.255.0
• Default router IP address : 192.168.3.1
(5) Basic specifications of Q173D(S)CPU/Q172D(S)CPU
(a) Module specifications
Item Q173DSCPU Q172DSCPU Q173DCPU Q173DCPU-S1 Q172DCPU Q172DCPU-S1
Internal current consumption
(5VDC) [A]
1.75
(Note-1)
1.44
(Note-1)
1.25 1.30 1.25 1.30
Mass [kg] 0.38 0.33
Exterior dimensions [mm(inch)]
120.5 (4.74)(H)
27.4 (1.08)(W)
120.3 (4.74)(D)
98 (3.85)(H)
27.4 (1.08)(W) 119.3 (4.70)(D)
(Note-1): The current consumption (0.2[A]) of manual pulse generator/incremental synchronous encoder connected to the internal I/F
connector is not included.