EasyManua.ls Logo

Mitsubishi Electric Melsec-Q172DCPU - Power Supply Module

Mitsubishi Electric Melsec-Q172DCPU
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 - 46
2 SYSTEM CONFIGURATION
2.5.2 Power supply module
(1) Power supply module specifications
Power supply modules specifications (Q61P-A1, Q61P-A2, Q61P, Q62P)
Item Q61P-A1 Q61P-A2 Q61P Q62P
Base loading position Q series power supply module loading slot
Applicable base unit Q35DB, Q38DB, Q312DB, Q63B, Q65B, Q68B, Q612B
Input power supply
100 to 120VAC
(+10%/-15%)
(85 to 132VAC)
200 to 240VAC
(+10%/-15%)
(170 to 264VAC)
100 to 240VAC (+10%/-15%)
(85 to 264VAC)
Input frequency 50/60Hz ±5%
Input voltage distortion factor 5% or less
Max. input apparent power 105VA 130VA 105VA
Inrush current 20A 8ms or less
(Note-4)
Rated output current
5VDC 6A 3A
24VDC —— 0.6A
External output voltage —— 24VDC±10%
Overcurrent protection
(Note-1)
5VDC 6.6A or more 3.3A or more
24VDC —— 0.66A or more
Overvoltage protection
(Note-2)
5VDC 5.5 to 6.5V
Efficiency 70% or more 65% or more
Allowable momentary power failure
time
(Note-3)
20ms or less
Dielectric withstand voltage
2300VAC per minute (Altitude 0 to 2000m (0 to 6561.68ft.))
Across inputs/LG and outputs/FG
Insulation resistance
Across inputs/LG and outputs/FG, across inputs and LG, across outputs and FG 10M
or more by
insulation resistance tester (500VDC)
Noise durability
• By noise simulator of 1500Vp-p noise voltage, 1
µ
s noise width and 25 to 60Hz noise frequency
• Noise voltage IEC 61000-4-4, 2kV
Operation indication LED indication (Normal : ON (Green), Error : OFF)
Fuse Built-in (Unchangeable by user)
Contact
output
section
Application
ERR.
contact
Rated switching
voltage/current
24VDC, 0.5A
Minimum switching
load
5VDC, 1mA
Response time OFF to ON: 10ms or less, ON to OFF: 12ms or less
Life time
Mechanical : 20 million times or more
Electrical : 100 thousand times or more at rated switching voltage/current
Surge suppressor None
Fuse None
Terminal screw size M3.5 screw
Applicable wire size
0.75 to 2mm
2
Applicable solderless terminal
RAV1.25 to 3.5, RAV2 to 3.5, thickness of 0.8mm or less.
Two solderless terminals can be connected to one terminal.
Applicable tightening torque 0.66 to 0.89 N•m
Exterior dimensions[mm(inch)] 98(H) × 55.2(W) × 90(D) (3.86(H) × 2.17(W) × 3.54(D) )
Mass [kg] 0.31 0.40 0.39

Table of Contents

Related product manuals