Mitsubishi Electric MELSERVO-JN Series - 5.2 Display sequence

5 - 2
5. DISPLAY AND OPERATION SECTIONS
5.2 Display sequence
Press the "MODE" button once to shift to the next display mode. Refer to section 5.3 and later for the
description of the corresponding display mode.
To refer to or set the gain/filter parameters, extension setting parameters, I/O setting parameters and
positioning setting parameters, make them valid with parameter No. PA19 (parameter writing inhibit).
Display mode transition Initial screen Function Reference
Point table
Status display
Diagnosis
Alarm
Basic setting
parameters
Gain/filter
parameters
Extension setting
parameters
I/O setting
parameters
Positioning setting
parameters
button
MODE
Servo status display.
appears at power-on. (Note)
Section 5.3
Sequence display, external signal display, forced
output of signal (DO), test operation, software version
display, servo motor series ID display, servo motor
type ID display, servo motor encoder ID display.
Section 5.4
Current alarm display, alarm history display, the
number of tough drive display, parameter error No.
display.
Section 5.5
Display and setting of point table data. Section 5.6
Display and setting of basic setting parameters. Section 5.7
Display and setting of gain/filter parameters.
Display and setting of extension setting parameters.
Display and setting of I/O setting parameters.
Display and setting of positioning setting parameters.
Note. When the axis name is set to the servo amplifier using MR Configurator, the axis name is displayed and the servo status is then
displayed.