Mitsubishi Electric MELSERVO-JN Series - 5.6 Point table mode; 5.6.1 Point table transition

5 - 13
5. DISPLAY AND OPERATION SECTIONS
5.6 Point table mode
In the positioning mode (point table method), the position data, the servo motor speed, the acceleration time
constant, the deceleration time constant, dwell, and the auxiliary function can be set.
5.6.1 Point table transition
After selecting the point table mode with the "MODE" button, pressing the "UP" or the "DOWN" button changes
the display as shown below.
Point table No.1
Point table No.2
Point table No.3
Point table No.4
Point table No.5
Point table No.6
Point table No.7
DOWN
UP