6 - 7
6. GENERAL GAIN ADJUSTMENT
(7) Clearing the one-touch tuning
POINT
The one-touch tuning result can be reset to the initial value by the clear (CLr)
mode and to the value before the adjustment by the back (bAC) mode.
One-touch tuning clea
mode selection
(a)
(b)
(c)
Pressing the "AUTO" and "SET" buttons for 3s or longer at the same time calls the
one-touch tuning clear mode.
The symbol of the one-touch tuning clear mode blinks.
Select "CLr" (the mode to return the initial value) or "bAC" (the mode to return the
value before the one-touch tuning) with the "UP" and "DOWN" buttons.
DOWNUP
When the one touch adjustment clear is completed, the status display at power-on is called.
One-touch tuning clear mode display (when returning to the initial value)
Status display at power-on (in the position control mode).
The selected one-touch tuning clear mode is performed. During the operation, the
symbol of the one-touch tuning clear mode is lit for 3s.
Clear the one-touch tuning with the "SET" button. (If no operation is performed in 10s, the one-touch
tuning clear mode is canceled. Then, it returns to the status display at power-on.)
6.1.3 Precautions for one-touch tuning
(1) In the internal torque control mode, the "AUTO" button is invalid.
(2) When an alarm or a warning occurs, the one-touch tuning is not available.
(3) While performing the following test operation modes, the one-touch tuning is not available.
(a) Output signal (DO) forced output
(b) Motor-less operation
(c) Forced tough drive operation
To Next Page
Loading...
