6 - 14
6. GENERAL GAIN ADJUSTMENT
6.4 2-gain adjustment mode
POINT
Use this mode to improve the response level after the one-touch tuning. Use
parameters No. PA09 or PB07 for fine adjustment.
Use the 2-gain adjustment mode for fine adjustment of the response level setting and the model loop gain.
(1) Parameters
(a) Automatically adjusted parameters
The following parameters are automatically adjusted by the auto tuning 1.
Parameter No. Abbreviation Name
PB06 GD2 Load to motor inertia moment ratio
PB08 PG2 Position loop gain
PB09 VG2 Speed loop gain
PB10 VIC Speed integral compensation
(b) Manually adjusted parameters
The following parameters are adjustable manually.
Parameter No. Abbreviation Name
PA09 RSP Auto tuning response
PB07 PG1 Model loop gain
(2) Adjustment procedure
Step Operation Description
1 Set to the 2-gain adjustment mode.
Set parameter No. PA08 (auto tuning mode)
to "
0".
2
During the operation, increase the response level setting (parameter No.
PA09), and reset the setting if vibration occurs.
Adjustment of the servo stability
3
During the operation, increase the model loop gain (parameter No. PB07),
and reset the setting if overshoot occurs.
Adjustment of the position track ability
(3) Adjustment description
The droop pulse value is determined by the following expression.
Droop pulse value (pulse) =
Rotation speed (r/min)
60
Servo motor resolution (pulse/rev)
Model loop gain setting
To Next Page
Loading...
