Mitsubishi Electric MELSERVO-JN Series - 11.11 Circuit protector; 11.12 EMC filter (recommended)

11 - 42
11. OPTIONS AND PERIPHERAL EQUIPMENT
11.11 Circuit protector
Use the circuit protector for the control circuit power supply (+24V, 0V).
Servo amplifier
Circuit protector
MR-JN-10A(1)
CP30-BA2P1M3A
MR-JN-20A(1)
MR-JN-40A
11.12 EMC filter (recommended)
For compliance with the EMC directive of the EN Standard, it is recommended to use the following filter. Some
EMC filters are large in leakage current.
(1) Combination with the servo amplifier
Servo amplifier
Recommended filter (Soshin Electric)
Mass [kg]([lb])
Model
Rated current
[A]
Rated voltage
[VAC]
Leakage current
[mA]
MR-JN-10A(1)
(Note)
HF3010A-UN
MR-JN-20A(1)
10 Max. 250 5 3.5 (7.72)
MR-JN-40A
Note. A surge protector is separately required to use any of these EMC filters. (Refer to section 11.13.)
(2) Connection example
MCCB
L
1
L2
Servo amplifie
r
1
2
3
4
5
6
E
(Note 2)
Surge protector 1
(RAV-781BYZ-2)
(OKAYA Electric
Industries Co., Ltd.)
(Note 2)
Surge protector 2
(RAV-781BXZ-4)
(OKAYA Electric
Industries Co., Ltd.)
(Note 1)
Main circuit
power supply
1
2
3
123
MC
EMC filter
Note 1. Refer to section 1.3 for the power supply specification.
2. The example is when a surge protector is connected.