Mitsubishi Electric MELSERVO-JN Series - 12.3 Connectors used for servo motor wiring; 12.3.1 Selection of connectors

12 - 11
12. SERVO MOTOR
12.3 Connectors used for servo motor wiring
POINT
The IP rating indicated for connectors indicates the dust and water proofing
levels when the connectors are installed to a servo amplifier or servo motor. If
the IP rating of the connector and the servo amplifier/servo motor differs, the
overall IP rating depends on the lowest of all.
12.3.1 Selection of connectors
Use the connector configuration products given in the table as the connectors for connection with the servo
motor. Refer to section 12.3.2 for the compatible connector configuration products.
HF-KN series
HF-KP G1/G5/G7 HG-KR G1/G5/G7
Encoder connector
Brake connector
Power supply connecto
r
Servo motor
Wiring connector
For encoder For power supply For brake
HF-KN(B)
HF-KP(B)G1/G5/G7
HG-KR(B)G1/G5/G7
Connector
configuration A
Connector
configuration B
Connector
configuration C