1 - 11
1. FUNCTIONS AND CONFIGURATION
1.7 Parts identification
USB communication connector (CN3)
Connect the personal computer.
Control circuit power supply connector (CNP2)
Connect the control circuit power supply.
Operation section
Used to perform status display, diagnosis, alarm,
point table and parameter setting operations.
Name/Application
Detailed
explanation
Display
The 3-digit, 7-segment LED shows the servo status
and alarm number
I/O signal connector (CN1)
Used to connect digital I/O signals.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Rating plate
Section 3.1
Section 3.3
Main circuit power supply connector (CNP1)
Connect the input power supply/built-in regenerative
resistor/regenerative option/servo motor/earth.
One-touch tuning button (AUTO)
Press this button to perform the one-touch tuning.
MODE SET
Used to set data.
Used to change the mode.
Used to change the
display or data in each mode.
Section 6.1
Chapter 5
Section 11.4
Section 1.5
Chapter 5
Section 3.2
Section 3.4
Section 3.1
Section 3.3
Section 3.4
Section 11.1
Serial number
Fixed part
(2 places)
To Next Page
Loading...
