2 - 2
2. INSTALLATION
2.1 Installation direction and clearances
CAUTION
The equipment must be installed in the specified direction. Otherwise, a fault may
occur.
Leave specified clearances between the servo amplifier and control box inside
walls or other equipment. Doing so may cause malfunction to the equipment.
A regenerative resistor is mounted on the back of this servo amplifier. The regenerative resistor causes a
temperature rise of 100
relative to the ambient temperature. Fully examine heat dissipation and
installation position before installing the servo amplifier.
(1) Installation of one servo amplifier
10mm or
more
Top
Bottom
10mm or
more
Control box
Wiring
allowance
80mm
Control box
40mm
or more
Servo
amplifier
40mm
or more
To Next Page
Loading...
