Mitsubishi Electric MELSERVO-JN Series - 3.3.3 CNP1 and CNP2 wiring method

3 - 10
3. SIGNALS AND WIRING
3.3.3 CNP1 and CNP2 wiring method
POINT
Refer to section 11.5, for the wire sizes used for wiring.
Use the supplied servo amplifier power supply connectors for wiring of CNP1 and CNP2.
(1) Servo amplifier power supply connectors
CNP2
CNP1
Servo amplifier
Connector for CNP1
FKC2,5/ 9-ST-5,08
(Phoenix Contact)
Connector for CNP2
FKCT 2,5/ 2-ST-5,08
(Phoenix Contact)
CNP1
CNP2
<Applicable cable example>
Wire size: 0.2 to 2.5mm
2
(AWG24 to AWG12)
Cable finish OD: to 4mm